Team Cobra


 

Frequently Asked Questions

I have a diamond bit for one of your stock lathes that I think needs replaced or resharpened.  Can you resharpen a diamond bit?  If so, how would I go about getting you to resharpen it and how much will it cost?  Will it be as good as new?
The diamond bit can be resharpened, if the diamond does not have too big of a chip on it. ( ie. if you can see the chip with the naked eye it most likely cannot be relapped) if the diamond can be relapped the cost is  $25.00 plus shipping. we do take MasterCard or Visa for payment .

If you are unsure if your diamond can be relapped just send it to us and we will decide if it can be relapped. don't forget to put your phone number in as well.

C&M Manufacturing, Inc.
657 South 4150 West
Salt Lake City, UTAH 84104